DA.C - View Single Post

asj410 · 10-11-2001, 12:41 PM

I was just curious if anyone had any effective methods for removing the markings from the plastic on Wooster/PPC/LP snap-together models without smearing them all over. I caught an earlier thread here that said that nail polish remover would smear the markings on the plastic tails of Herpa models. Since paint stripper would just dissolve the entire model, I'm not quite sure what else I might be able to use to get a clean white model. I suppose I could just sand the markings off, but I'm not sure if that's my best option.

Thanks!

Andy

10-11-2001, 12:41 PM	#1
asj410 Waiting for Comair's call Join Date: Jun 2000 Location: Honolulu, Hawaii Posts: 311	Removing markings from plastic I was just curious if anyone had any effective methods for removing the markings from the plastic on Wooster/PPC/LP snap-together models without smearing them all over. I caught an earlier thread here that said that nail polish remover would smear the markings on the plastic tails of Herpa models. Since paint stripper would just dissolve the entire model, I'm not quite sure what else I might be able to use to get a clean white model. I suppose I could just sand the markings off, but I'm not sure if that's my best option. Thanks! Andy